Page 1 of 1

I-TASSER suit stuck at the step of "running pairing"

Posted: Wed May 12, 2021 9:45 pm
by Wei Liu
Hello,

I set up the I-TASSER suit(5.1) on my server and try to run one of my sequences whose length is about 1200 but the program seems to stuck in the step of "2.4.2 running pairing" over 7 hours so far. I wonder if it is normal? If not, is there any idea where is the problem gonna be?

Thank you in advance!

Re: I-TASSER suit stuck at the step of "running pairing"

Posted: Fri May 14, 2021 12:30 pm
by robpearc
Typically, this step should not take long. However, it may for longer proteins (length > 500). Were there any error messages output by the program?

Re: I-TASSER suit stuck at the step of "running pairing"

Posted: Sun May 16, 2021 1:55 pm
by Wei Liu
My sequence is about 1300. And the program doesn't output any not error message. I let it run from Wednesday noon till now and it has reached the step of "4.1 run simulation". May I ask what resource this program needs most, CPU or GPU?

Thanks a lot!

Re: I-TASSER suit stuck at the step of "running pairing"

Posted: Mon May 17, 2021 3:56 am
by robpearc
I-TASSER will run on your CPU resources. Even so, this is an excessively long running time. If there was no error in the program, it might be best to check your server to make sure everything is running properly.